Struers Discotom-60, Instruction Manual

Page: 54 / 258

Discotom-60 /-65
Instruction Manual
50
Message/Error Type Explanation Action
Frequency inverter
communication error! ERROR
(#20) Data communication with
the frequency inverter
failed (D-65 only). Switch off and on at Main Switch.
If the error message is still displayed,
contact a Struers service technician.
Contactor K1-K3 not
activated,
Please check the hood
MESSAGE
(#21) The start button

was
pressed, but none of the 3
motor contacts were
activated (D-60 only).
The cutting chamber
hood may not be fully
closed.
Check that the hood is closed properly.
If the error message is still displayed,
contact a Struers service technician.
Cutting motor blocked!
Please reduce the motor
load
MESSAGE
(#22)
During cutting, motor load
exceeded its safe limit. Reduce feed speed or cutting force.
Check also that the sample is properly
secured as a sample that is not correctly
secured can trap the cut-off wheel with
enough force to stop it rotating.
Cutting motor will not
stop!
Please call service
technician
ERROR
(#23) A motor terminal failure
occurred. After pressing
the stop button

, the
motor did not stop.
(D-60 only).
Switch off the Discotom at the Main Switch
and call a Struers service technician.
Frequency inverter fault!
Lenze error code: XX
ERROR
(#25) Frequency inverter failure
(D-65 only). Switch off the Discotom at the Main Switch
and call a Struers service technician.
Feed motor not
stopped!
ERROR
(#26) After pressing stop button

, the motor did not stop.
Switch off the Discotom at the Main Switch
and call a Struers service technician.
Cutting table position
not found! ERROR
(#27) During the movement of
Y-table, a position was
not found within a set
amount of time. The feed
motor module is most
likely defective. Switch off the Discotom at the Main Switch
and call a Struers service technician.