Struers Discotom-60, Instruction Manual

Page: 52 / 258

Discotom-60 /-65
Instruction Manual
48
Message/Error Type Explanation Action
Cutting finished, end
position reached MESSAGE
(#7)
Process in progress! MESSAGE
(#8) Operator tried to change
certain parameters that it
is not possible to change
during a cutting operation,
for example, ”Units”. Wait until the cutting operation has finished
before carrying out this change.
Process stopped MESSAGE
(#9) Cutting operation
terminated because the
STOP button was been
pressed.
Do not operate the valve
during cutting! MESSAGE
(#10) The cooling valve was
turned to the cleaning
position during cutting. Turn the cooling valve back to the cutting
position. Wait until after the cutting operation
has finished before using the cooling valve.
Too many feed
reductions, process is
aborted! MESSAGE
(#11) It was not possible to
complete a cutting
operation. The automatic
feed speed control
feature reduces in steps
of 20% a maximum of 4
times after which, if motor
load is still too high, the
cutting operation is
terminated. The three most likely causes are:
The feed speed was much too high, before
cutting started.
The cut-off wheel being used is not suitable
for cutting the sample.
The motor RPM is not appropriate (D-65
only).
Consult Struers or your local dealer for
information on how to cut this type of
material.
Editing restricted by
operating mode MESSAGE
.(#12) Operator tried to change
certain parameters that
are locked when
Discotom is in the current
operating mode. If the parameter has to be changed, either
the operation mode has to be changed to a
menu level where the parameter can be
changed, or the operation mode can be
changed to “Configuration” mode (in which
all parameters can be changed). Changing
the operation requires that the operator
enters the correct pass code.