Struers Discotom-60, Instruction Manual

Page: 18 / 258

Discotom-60 /-65
Instruction Manual
14
The Cutting Display displays three types of information:
A : Cutting Mode
B : Cutting Parameters, and
C : Motor Information
The top area of the display (
A ) displays the selected Cutting Mode:
Manual Cutting or Automatic Cutting mode.
In Automatic Cutting mode, the middle area of the display (
B )
displays information about the Cutting Parameters: Feed speed, Stop
position and Motor RPM (D-65 only).
The Cutting Parameters can be set both before and during cutting.
The set value is displayed to the left of the bar graph. The actual
value (during cutting) is displayed to the right of the bar graph.
The bottom area of the display (
C ) displays Motor information: Motor
load and Motor temperature. The values displayed are in relative (%)
values.
Reading the Cutting Display
Cutting Mode
Note:
In Manual Cutting mode, Cutting Parameters are not displayed.
This area of the display will be blank.
Cutting Parameters
Motor Information
B
A
C