–
Clean the chain using paraffin derivatives
such as washing petrol, wear protective
clothing and observe the manufacturer’s
safety notes.
–
When using a steam jet, use without using
additives.
–
After cleaning, blow dry the chain at once to
remove any water in the chain links and on
the surface. During this procedure the chain
should be moved several times.
–
Spray Linde chain spray immediately, move
the chain while spraying by raising and low-
ering the fork carriage.
NOTE
Lifting chains are safety components. The use
of cold cleaners, chemical cleaning agents
and caustic or acidic and chlorinated fluids
can be a direct cause of damage to the chain.
NOTE
Trucks in service in the food industry must be
lubricated with an oil approved for the food
industry instead of chain spray.
Check seat belt for condition and
correct operation (option)
NOTE
For safety reasons the condition and proper
operation of the retention system should be
inspected regularly (monthly).
Under extreme operating conditions this check
is required daily before taking the truck into
operation.
–
Pull belt (1) out fully and inspect for fraying.
–
Check lock (2) for correct operation and the
retractor for proper return of the belt.
–
Check covers for damage.
–
Check the automatic lock.
–
Park the truck on level ground.
d3591093
3
1
2
Maintenance
5
Chassis, bodywork and fittings
234
5001 801 1625 EN - 05/2022 - 03
Summary of Contents for 5410
