Still 5410, Original Instructions Manual

Page: 164 / 288

6310 005 Tire pressure monitor-
ing system
The monitor is fixed on the right side in the
cabin.
Programming of Monitor
Programming of Transmitter ID
NOTE
If the user wants to program a new transmit-
ter into the monitor, the operation should be
finished in programming mode. At this time,
make sure the transmitter to be programmed
has not been screwed onto the valve yet.
Screw on transmitters until the programming
has been finished and the monitor returns to
normal mode.
Each transmitter has 4 groups of ID, for exam-
ple when program the transmitter with ID of
001 001 001 158 to front right tire position, the
user only needs to input the last 3 digits “158”.
Monitor will record the rest 3 groups of ID au-
tomatically. Operation steps are as following:
–
After monitor is powered, the screen will
display “NSP”, press P for 3 seconds to
access the system programming mode, the
first interface is for ID programming as
shown below:
–
Press any of the four arrow keys to choose
the tire position which needs to be program-
med with a transmitter.
–
Then press S for 3 seconds to start pro-
gramming and the digit flashes, then press
up or down arrow key to adjust the number.



Operation
4
Optional equipment
154 5001 801 1625 EN - 05/2022 - 03