NOTE
Driver's cabs with fixed closed doors or brack-
et doors meet the safety requirements for driv-
er restraint systems. The seat belt may also
be used. It must, however, be fastened when
driving with doors that are open or have been
removed. PVC doors do not constitute a driver
restraint system. For trucks with the "speed
reduction" special function, the seat belt must
be worn even at the reduced speed.
The automatic blocking mechanism prevents
the belt from being extended whenever the in-
dustrial truck is on a steep slope. It is then not
possible to pull the belt any further out of the
retractor. To release the automatic blocking
mechanism, carefully move the industrial truck
so that it is no longer positioned on a slope.
While using the truck (e.g. driving, operating
the lift mast etc.), the driver should adopt a
sitting position as far back as possible so
that his/her back rests against the seat back-
rest. The automatic blocking mechanism for
the belt retractor offers sufficient freedom of
movement on the seat for normal use of the
truck.
Fastening the seat belt
–
Pull the seat belt (2) smoothly out of the
retractor to the left.
–
Position belt over the lap, not over the
stomach.
–
Snap the buckle guide (1) into place in the
buckle (4).
–
Check seat belt tension.
The belt must fit close to the body.
Unfastening the seat belt
–
Push the red button (5) on the buckle (4).
–
Manually feed the buckle guide (1) back in-
to the retractor (3).
Operation
4
Standard equipment
76
5001 801 1625 EN - 05/2022 - 03
Summary of Contents for 5410
