T
ECHNICIAN FUNCTIONS:
( ) Check general conditions of the machine
(defects, dents and others).
Note:
( ) Instruct on Emergency stops (hand-
brakes; see page 44 of this manual).
( ) Fill-out the guaranty certificate and the
terms of technical delivery.
( ) Check engine oil level before driving the
machine.
( ) Install and verify the left/right discs, each
according to its proper side.
( ) Check oil level of the hydraulic reservoirs.
( ) Review and adjust the slide-gate.
( ) Check radiator fluid level.
( ) Verify the conveyor belt alignment, with
( ) Re-tighten wheel bolts.
the tank empty..
( ) Check tire pressure.
( ) Verify the discs rotations (720 RPM).
( ) Lubricate all indicated points of the
( ) Inspect the heat exchanger air flow, which
machine.
should be sucked out the back-side of the
machine.
( ) Check wheel alignment.
( ) Process one tank fill, and check conveyor
( ) In case of leakage, re-tighten clamps and
belt alignment with the tank full.
couplings.
( ) Again, process one tank fill and check for
( ) Verify that the screws and belts are tight
hydraulic oil leaks.
and lubricate periodically.
( ) Check and verify that the pneumatic air
( ) Instruct that all screws should be re-
bags are at a height of 285mm, if not adjust
tightened after the first 10 working hours of
accordingly.
operation.
( ) Deslouvor the machine’s manual.
( ) Instruct on working with the GPS, Auto-
pilot, and the Controller 4500.
( ) Instruct on control panel functionality.
( ) Emphasize the importance of not mixing
different oil brands: use only the hydraulic oil
specified in this manual.
INSTRUCTIONS AND DIRECTIVES
TECHNICAL DELIVERY TERMS (auto-piloted)
(this form must be completed by the technician and sent to Stara)
CUSTOMER DATA:
PURCHASED PRODUCT DATA:
MODEL:
MANUFACTURED DATE:
MACHINE SERIAL Nº:
ENGINE SERIAL Nº:
WHEEL MOTOR SERIAL Nºs:
WATER PUMP SERIAL Nº:
NAME:
PHONE:
OPERATOR(S) NAME(S):
ADDRESS:
TECHNICIAN/DELIVERY AGENT:
INVOICE Nº:
DELIVERY DATE:
/ /
cut and send
Page 1 of 2
