Stahl EC-940-DUA Series, Instruction Manual

Page: 71 / 606

Instruc
tion manual - English - EN
69 MNTCMPXT_1824_EN
11.2.1.5 Fuses replacement
Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
If necessary, the connector board's fuses can be
replaced. The new fuses must comply with the
directions given in the table.
FUSES REPLACEMENT
Supply voltage Fuse (FUS1) Fuse (FUS2)
24Vac, 50/60Hz T 4A H 250V 5x20 T 4A H 250V 5x20
120Vac, 50/60Hz T 2A H 250V 5x20 T 4A H 250V 5x20
230Vac, 50/60Hz T 1A L 250V 5x20 T 4A H 250V 5x20
Tab. 13
FUSE
FUSE
100nMBW3
L
N
VAR3
VAR1
AC
AL1
AL2
AL3
AL4
AL5
COM
RL1
RL1
RL2
RL2
GND
W
GND
B
A
B
A
IN
J1
J9
J6
J2
J3
J8
J4
J7
FUS1
FUS2
VAR2
VIDEO - 1
VIDEO - 2
RS485
ADDRESS & PROTOCOL
FUS2
Fig. 127
11.2.2 Extraordinary (to be done only
under particular circumstances)
Any other intervention that is not
comprised in the routine interventions
must be done in absence of potentially
explosive atmosphere.
For damage to any parts, repair or
replacement must be done by, or under
supervision of STAHL.
Whenever replacing the parts as indicated,
always use STAHL original spare parts
and meticulously follow the maintenance
instructions supplied with every spare parts
kit.
The manufacturer declines all liability for
damage to any of the apparatus mentioned
in this handbook, when resulting from
tampering, use of non-original spare parts,
installation, maintenance and repairs
performed by non-authorised, non-skilled
personnel.
For all maintenance interventions, we
recommend you return the product to the
laboratory that will perform all required
operations.
12 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.