Stahl EC-940-DUA Series, Instruction Manual

Page: 72 / 606

EN - English - I
nstruc
tion manual
70 MNTCMPXT_1824_EN
13 Troubleshooting
PROBLEM The product does not go on.
CAUSE Wiring error, blown fuse.
SOLUTION Make sure the connections are
correct. Check the continuity of
the fuses and replace them with
the indicated models should they
fail.
PROBLEM The shooting area do not
correspond to the selected
preset position.
CAUSE Loss of absolute position
reference point.
SOLUTION Follow the calibration procedure
for Pan & Tilt from the keyboard
(refer to the relative manual) or
reset the unit by switching it on
and off.
PROBLEM The monitor does not show
the picture taken but shows
an image of the type:
Address : 1
Protocol : MACRO
RS485-1:38400 N81 RX
RS485-2:38400 N81 REPEAT
232 : FW UPGRADE ONLY
FW: 0a (Jun 4 2009)
HW: 000-0001
DIP1.1: VIEW CONF. ON
CAUSE Display Configuration dip-
switch rocker (DIP1, SW1).
SOLUTION Switch off the pan & tilt, switch
down the dip-switch (DIP1, SW1).
Switch-on the unit again.
PROBLEM After turning the device on,
the following is displayed on
the screen (analog version):
Address : 1
DE-ICE PROCEDURE
IN PROGRESS…
REMAINING MINUTES:59
CAUSE The ambient temperature is too
low.