Stahl EC-940-DUA Series, Instruction Manual

Page: 31 / 606

Instruc
tion manual - English - EN
29 MNTCMPXT_1824_EN
6.19 Configuration of the version
with IP board
Operating mode valid only on version with
MPEG4 Encoder.
The unit can be configured in one way only. Set the
DIP exactly as shown in the table.
CONFIGURATION OF THE VERSION WITH IP BOARD
Address 1
Protocol MACRO
Baud rate 38400
Serial line Two-way RS-422 line
Serial line termination (1) ON
Serial line termination (2) ON
Tab. 8
Once the dip-switches are configured, the P&T IP
parameters can be configured.
6.20 Ground connection
CAUTION! The external equipotential
connections must be set up through the
eyelet on the outside of the product. Do not
use as a protective terminal.
Fig. 45
To make the equipotential connection
use cables with a suitable section: 4mm²
(11AWG).
The ring terminal for external bonding connection is
provided by the manufacturer.
The equipotential earth connection is necessary for
carrying out additional connections required by law.
In any case a protection earthing conductor must be
applied to the inside connector (J1, 6.5 Connection of
the power supply line, page 19).