Spectrum DX8, Instruction Manual

Page: 34 / 208

34 SPEKTRUM DX8 • RADIO INSTRUCTION MANUAL
To select the Timer Mode- Inhibit, Count Down or Stop Watch
Highlight Mode then press.
Select Inhibit, Count Down or Stop Watch. Press the roller to accept.
To program a Time
Rotate the roller to highlight Time then press to access. You can highlight the
seconds or minutes. Press the roller to access minutes or second.
Rotate the roller to select the desired time. Press to accept.
To program a Tone, vibe, Tone/ vibe or Inhibit
Rotate the roller to highlight Tone then press to access. You can
Select Inh. Tone, Vibe or Tone /Vibe
To Select the Timer Start Method
Rotate the roller to highlight Start then press to access. Five start options are
available: Trainer switch, Throttle, Throttle 1-Time, L Trim and R Trim.
Throttle 1-time - The timer starts when the programmed throttle position is
exceeded and will continue regardless of the throttle position.
Throttle - The timer starts when the programmed throttle position is exceeded.
Anytime you lower the throttle below the programmed position, the timer will
pause then continue anytime the throttle is raised above that position. (This is
useful for flying electric models where the motor run time, not the flight time, is
important.)
Rotate the roller to select the desired Start method (Trainer, Throttle, Throttle
1-Time, L Trim, R Trim). Press to accept.
Programming a Throttle Stick Position-
Only if Throttle Start is Selected
If you select Throttle or Throttle 1-Time in the Start function, the Stick appears
below Start in the Timer screen. This is the stick position where throttle activates
the timer. Rotate the roller to highlight Stick then press to access the Stick values.
You can adjust the value from 0 to 100%. This correlates to the actual throttle
stick position.
Rotate the roller to select the desired Stick value then press the roller to accept the
displayed value.
To Reset the Internal Timer
There are a couple of ways to reset the internal timer. Rotate the roller to highlight
Internal: Reset then press the roller to reset the internal timer to 0:00:00
To reset the Count Down or Stop Watch timer on the main screen,
press the Clear button.
EN