Note:
The functionality described below only applies to
GPS
and
Glonass
. Other
installed satellite systems, such as Galileo, still have their first generation of satel
lites in orbit.
GSG offers three options to configure satellite constellations:
I.
The
Default
setting refers to the constellation state for April 22, 2015.
II.
Constellation-wide setting of the satellite generation, e.g., by setting all GPS satellites to
Block IIR-M
:
Figure 3-20:
Assigning one constellation block to all satellites
To access this configuration view:
1.
Navigate to
Select
> [
Select Scenario
] >
Configure Scenario
:
View 3/3
2.
Next to the desired
Satellite System
enter a
number of satellites
greater than "0",
or
Auto
(see "Number of Satellites" on page 71), and press
Enter
to open the first
configuration view, then the
RIGHT arrow
key to open View 2/2.
Note:
The
G##
numbers refer to the individual GPS satellites (Glonass satel
lites are named
R##
).
III.
Explicitly
specify
the constellation for each individual satellite, using GSG StudioView:
74
CHAPTER
3
•
User Manual GSG-5/6 Series
Rev.
26
3.5 "Select" Menu
Summary of Contents for GSG-5 series
