USB
Ethernet
GPIB
: Set the address here.
SCPI-Raw
network clients can use a socket connection to port 5025 and send/receive
SCPI commands terminated by a newline.
The
10 MHz
input can also be selected via this view. When it is selected, a small symbol con
taining the text
EXTREF
is displayed in the upper right corner of the GSG display.
In all models except GSG-52 and GSG-53, the
PPS output
on the rear panel can be configured
to send 1, 10, 100 or 1,000 pulses per second. The pulse ratio is always 1/10 (1/10 high,
9/10 low).
PPS Out
is active on the rising edge of the signal.
3.6.3.1
Network Configuration
To access the
Network configuration
view, navigate to
Options
>
Interface and Reference
>
Select
Interface Type
:
Ethernet
. Highlight the menu item
Network
, and press
enter
; the
Network
configuration
screen will be displayed:
IP Configuration
Figure 3-32:
Static IP address configuration
In the
Network configuration
screen, you can configure GSG either to obtain an IP address
automatically from a DHCP server, or you can specify a static IP address.
To specify a static IP address manually, you must provide:
the
IP address
the
network mask
and the
gateway
.
Note:
In order for the
ephemeris download
to work, the correct DNS address must
specified, either by setting
Options
>
Interfaces and Reference
>
Network
>
Obtain
92
CHAPTER
3
•
User Manual GSG-5/6 Series
Rev.
26
3.6 "Options" Menu
Summary of Contents for GSG-5 series
