Spectracom GSG-5 series, User Manual With Scpi Manual

Page: 240 / 378

Example
SOURce:SCENario:CONTrol start;*WAI;SOURce:SCENario:LOG?
Wait until scenario is running and then request NMEA position.
RSG Example
SEND:
*WAI?
SEND:
SOURce:SCENario:VELocity 123.400,27.25, 210.8000
SEND:
SOURce:SCENario:PRYRate 123.400,-2.0000,2.0000,1.0000
Wait until the next 100 msec interval and issue the following commands.
6.3.2 SYSTem: Subsystem Commands
6.3.2.1 SYSTem:ERRor?
Function
This SYSTem command queries the error queue for an ASCII text description of the next error
and removes it from the queue. The error messages are placed in an error queue, with a FIFO
(First In-First Out) structure. This queue is summarized in the Error AVailable (EAV) bit in the
status byte.
The System Error command is extended with relevant command and protocol errors. It will
allow the user to determine:
Scheduled commands arrive too late to meet their required pre-processing time based
on their timestamps.
The user can configure protocol to flag error in situation where:
More than one position command is received during same epoch, and the com
mands contradict (not complement) each other. Values are not analyzed to determ
ine contradiction, but only type of data (e.g., two position information commands
are deemed to contradict, even if the actual position would not change.). In these
situations only the last received information is served (no queue system used). The
default configuration is NOT to flag error.
224
CHAPTER
6
•
User Manual GSG-5/6 Series Rev. 26
6.3 Command Reference