Spectracom GSG-5 series, User Manual With Scpi Manual

Page: 327 / 378

Returned Format
<decimal data> = the sum (between 0 and 16384) of all bits that are true. See the table for
STATus:QUEStionable:CONDition
6.3.6.7 STATus:PRESet
Function
Enables Device Status Reporting. This command has an SCPI standardized effect on the status
data structures. The purpose is to precondition these toward reporting only device-dependent
status data.
It only affects enable registers. It does not change event and condition registers.
The IEEE-488.2 enable registers, which are handled with the common commands *SRE
and *ESE remain unchanged.
The command sets or clears all other enable registers. Those relevant for this device are
as follows:
It sets all bits of the Device status Enable Registers to 1.
It sets all bits of the Questionable Data Status Enable Registers and the Operation Status
Enable Registers to 0.
The following registers never change in the GSG-5x, but they do conform to the stand
ard :STATus:PRESet values.
All bits in the positive transition filters of Questionable Data and Operation status
registers are 1.
All bits in the negative transition filters of Questionable Data and Operation status
registers are 0.
Command Syntax
STATus:PRESet
6.4 Sensors Command Reference
As the GSG unit simulates a user’s movement along a given trajectory, it can also be con
figured to output sensor data generated by the user dynamics. The generated sensor output
data is a result of the user exercising his six degrees of freedom:
6.4 Sensors Command Reference
CHAPTER
6
•
User Manual GSG-5/6 Series Rev. 26
311