PRO/100+
™
LAN Adapter Installation
SY-D6IGA
90
Important:
When using command line options with the
.LAN
driver
for
NWSERVER,
make sure the equal sign is followed by a value.
Otherwise, unpredictable results may occur.
General Instructions
1. Install
NetWare 3.12
or
4.10
according to the NetWare
instructions.
2. Copy the
PRO/100+
server driver
(\NWSERVER\E100B.LAN)
and any updated
NLMs,
to the NetWare server's hard drive.
l
If you can't log in to the server (before starting the server)
copy the E100B.LAN driver from the \NWSERVER
directory on the Configuration and Drivers disk to the root
directory of the server's hard drive.
l
If you can log into the server, copy the driver to the
SYSTEM subdirectory. If you do this, you won't need to
specify a path on the load line. If you copy it to another
directory, make sure the LOAD statement includes the
correct path.
3. Start the server. At the server console, load
NBI, MSM
and
ETHERTSM
(for
NetWare 3.12
load
NBI31X, MSM31X
and
ETHERTSM
) in this order.
Next, load and bind the server driver as follows:
LOAD C:<PATH>\E100B SLOT=x FRAME=ETHERNET_802.2
BIND IPX TO E100B NET=xxxxxxxx
Where:
SLOT=x
Specifies the
NBI (NetWare Bus Interface)
slot
number. Substitute
x
with the valid value for the adapter. You
will be prompted with the slot number(s) of installed PRO/100+
adapters. The
NBI
numbers are different from the slot number
indicated in the
SETUP.EXE
utility.