Hardware Setup
SY-D6IGA
15
6. (Dual Processor Configuration)
Install the Second Processor in Slot2 #2
If you are installing a second processor in Slot2 #2, apply the same
procedure as in
step 5.
However, in
step 5(a),
clip the DRM Top onto
the processor with the mounting holes facing
towards
the heat sink.
Notice 1:
When installing two processors, make sure the front side
bus and working frequency are identical for both processors. Do
NOT install different types of CPU at the same time, for example,
Pentium
®
II Xeon ™ (400/450 MHz) and Pentium
®
III Xeon™
(500/550 MHz) processors may not work properly when installed
together in a dual configuration. We strongly recommend using two
processors with the same specification number in dual processor
configuration.
Notice 2:
If two processors are installed in the DRM assembly, then
the clearance between processors will be insufficient and not allow
the use of a heat sink & fan assembly on the second processor (the
one installed in Slot2 #2). Cooling of the second processors will be
provided by the two DRM fans. If you install a heat sink on the
second processor, only use a narrow gage heat sink so as not to
obstruct the flow of air between the two processors.
7. (Single Processor Configuration)
Install the Termination Card in Slot2 #2
If only one processor is installed in your system, you are required to
insert the
FSB Termination Card
in the available Slot2 #2.
Note:
If you are using a single processor, you must install the
processor in Slot 2 #1,
then insert the
Termination Card in Slot 2
#2,
in this order.