Hardware Setup
SY-D6IGA
28
Step 14. Power Button Enable (JP11)
Your system can be powered on either by pressing the power switch
or by entering a system password at the prompt. (Note that the
system password can be configured in the BIOS “SOYO COMBO
Setup” ).
In case you forget the system password, you will be denied access
to the system. To avoid this, you can short pin 1-2 on jumper JP11,
which will override the password and always enable the power
button function.
Power Button
Enable
Always Enable
The Power Button
Power Button Function
According to BIOS Setting
JP11 Setting
Short pin 1-2 to
always enable the
Power Button function.
Short pin2-3 for a
Power Button function
according to BIOS setting.
Step 15. Power On
You have now completed the hardware installation of your
motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note:
If you fail to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
Repeat this operation until you get the following screen.
3
2
1
3
2
1