Source Technologies STP.1120N, User Manual

Page: 106 / 158

4 | Menu System
STp.1120n User’s Guide 96
The Top-of-Form Sensor has two sensor pods that can sense the distinguishing
characteristics of paper types. The pods are mounted on a slider; the inside sensor can
read characteristics on the right edge of the media while the outside sensor can read
characteristics in the center of the media. Please refer to the Top-of-Form adjustment
settings in the media installation section of the manual for more information on selecting
the appropriate settings.
Select from the following options:
Table 1: Paper Sensor Options
Ribbon Mode
The Ribbon Mode option allows the user to enable and disable Ribbon Mode and note
the type of ribbon being used.
Ribbon Mode has three settings:
• Coated In
• Coated Out
• None
Print Adjust
The Print Adjust selection allows for the adjustments of both the darkness and the
sharpness of print quality as well as horizontal and vertical adjustments.
Selecting the plus or minus buttons respectively increases or decreases the values.
Changes to the values may also be made by selecting the field and entering the
appropriate values using the numeric keypad.
a. Darkness
Paper Sensor Type Paper Sensor Side
Gap Inside
Outside
Mark on Top Inside
Outside
Mark on Bottom Inside
Outside
Notch Inside
Outside
Continuous Inside
Outside