Sony RDR-VX410, Service Manual

Page: 59 / 132

2-19
1
3 SCREWS
A
B
C
2
MOTOR CAPSTAN ASS'Y
2 BELT PULLEY
1
HOOK CAPSTAN
HOOK
2-4-25 Hook Capstan, Belt Pulley Removal
1) Remove the Hook Capstan 1 after realeasing Hook in the
direction arrow as shown in detail drawing.
2) Remove the Belt Pulley
2
.
Note: Take extreme care not to get grease on Belt Pulley 2 at
assembling or reassembling.
Fig. 2-38 Belt Pulley Removal
2-4-26 Motor Capstan Ass’y Removal
1) Remove the 3 Screws 1 .
2) Remove the Motor Capstan Ass’y 2 .
Assembly:
1) Match the 3 holes of Motor Capstan Ass’y 2 to the 3 holes of
Main Base. Be careful not to drop or knock the Motor Capstan
Ass’y
2
.
2) Tighten the 3 Screws 1 in the direction of arrow as shown detail
drawing.
Note:
After tightening screws, check if there is gap between the
head of screws and the top side of Main Base. There should have no
gap between the head of screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
Fig. 2-39 Motor Capstan Ass’y Removal