Sony Handycam Vision DCR-TRV5, Service Manual

Page: 109 / 165

5-30
5-3. VIDEO SECTION ADJUSTMENTS
NTSC model : DCR-TRV5
PAL model :
DCR-TRV5E
3-1. PREPARATIONS BEFORE ADJUSTMENTS
Use the following measuring instruments for video section
adjustments.
3-1-1. Equipment Required
1) TV monitor
2) Oscilloscope (dual-phenomenon, band above 30 MHz with
delay mode) (Unless specified otherwise, use a 10 : 1 probe.)
3) Frequency counter
4) Digital voltmeter
5) Audio generator
6) Audio level meter
7) Audio distortion meter
8) Audio attenuator
9) Regulated power supply
10) Alignment tapes
• Tracking standard (XH2-1)
Parts code: 8-967-997-01
• SW/OL standard (XH2-3)
Parts code: 8-967-997-11
• Audio operation check for NTSC (XH5-3)
Parts code: 8-967-997-51
• System operation check for NTSC (XH5-5)
Parts code: 8-967-997-61
• BIST check for NTSC (XH5-6)
Parts code: 8-967-997-71
• Audio operation check for PAL (XH5-3P)
Parts code: 8-967-997-55
• System operation check for PAL (XH5-5P)
Parts code: 8-967-997-66
• BIST check for PAL (XH5-6P)
Parts code: 8-967-997-76
11) Adjustment remote commander (J-6082-053-B)
12) CPC-8 jig (J-6082-388-A)
13) IR receiver jig (J-6082-383-A)
14) Extension cable (80P, 0.4 mm)
For extension between the DD-110 board (CN802) and the VC-
207 board (CN010) (J-6082-395-A)
15) Power code (J-6082-223-A)
Note:
Connect the adjustment remote commander to the LANC jack,
and set the HOLD switch to the “ADJ” side.
When performing adjustments, refer to the layout diagrams
for adjustment related parts beginning from page 5-52.