65
Enabling the pellet level sensor
At the end of the storage unit’s installation it is necessary to activate the
pellet level sensor in the boiler’s display. For this, you should enter the
technical menu. (Password only provided to authorized technical
personnel)
Within this menu, you should enter the General Settings, and in the
Pellet Level Sensor menu you should press Set, and then the keys “+” and
“-“ until it shows On on the display.
When the storage unit runs out of pellets, the level sensor sends a signal
and an alarm appears in the boiler’s display (A15 code). You should refill
the storage unit with pellets, reset the alarm and restart the boiler.
Boiler startup
With the storage unit properly fixed to the boiler (right or left side) you
should carry out the hydraulic connections and the connection of the
boiler to the fumes outlet.
After making the connections, you should introduce some pellets inside
the storage unit and start the operation of the boiler. You must observe
the pellets falling from the storage unit to the boiler’s internal tank and
check if the level sensors work properly.
If the sensors do not work properly, you should remove them and
re--adjust the sensitivity.
ON
OFF
OF
F
+
OK
OFF
MENU
OFF
MODE
OFF
ESC
OFF
-
MAN
AUT
OFF
esc
Set
<
Technical Menu
>
ON
OFF
OF
F
+
OK
OFF
MENU
OFF
MODE
OFF
ESC
OFF
-
MAN
AUT
OFF
esc
Off
Set
<Pellet Level Sens>
Summary of Contents for SZM A 18 KW
