l
PWR Limit
: The inverter maximum output power set by one of the power limiting options:
o
RRCR
o
Smart energy manager (Feed-in limitation)
o
P(f)
o
Q(U)
l
Cos Phi
: The ratio between active to reactive power
l
Power Prod
: The power produced by the inverter
For more information, refer to the following application notes:
o
Power Control Application Note
, available on the SolarEdge website at
http://www.solaredge.us/files/pdfs/application_note_power_control_configuration.pdf
o
Feed-in Limitation Application Note
, available on the SolarEdge website at
http://www.solaredge.us/files/pdfs/products/feed-in_limitation_application_note.pdf
Battery Status
This screen is displayed only when the battery is configured, and shows the battery identification
information, its charging status and power, and the operating mode.
B S N : X X X X X X X X X I D : 2 4
S O E : 8 9 %
W W W W W
P W R : 0 W
T o t a l : 0 W h
S t a t e : I d l e
l
BSN
: Battery serial number
l
ID
: Battery identification - should be 24 as set up above
l
SOE
: State of Energy - the battery capacity percentage (calculated as Available Energy\Max. Energy)
l
PWR
: The charging or discharging power (in Watts) according to the battery state (see below)
l
Total
: The total discharged energy in Watt/hour
l
State
: The battery status: Charging/ Discharging, Idle, Init (pre-heating) or Fault <error code>.
Time Of Use Status
This screen is sisplayed only if TOU is configured, and shows information about the TOU settings for the
site.
N a m e : x x x x
L a s t S y n c : < D a t e >
S o u r c e : < R e m o t e >
S e t U n t i l : < d a t e >
l
Name
: The TOU profile file name
l
Last Sync
: Date when the time-of-use profile was loaded from the monitoring portal
l
Source
: the source from which the TOU profile was uploade:
o
Remote - Profile uploaded from the SolarEdge monitoring portal
o
Local - Profile uploaded from an SD card
l
Set Until
: The date until the current profileis applicable
SolarEdge
-
StorEdge Installation Guide MAN-01-00262-1.0
54
Battery Status