l
Align the two indentations in the inverter enclosure with the two triangular mounting tabs of the
bracket, and lower the inverter until it rests on the bracket evenly.
Figure 12: Hanging the inverter on the bracket
5. Secure the StorEdge Connection Unit bracket to the wall:
l
Mark the location of the bracket screw for the Safety SwitchStorEdge Connection Unit and drill the
hole.
l
Fasten the bracket using a standard bolt.
l
Verify that the bracket is firmly attached to the mounting surface.
Figure 13: StorEdge Connection Unit bracket
6. Insert the two supplied screws through the outer heat sink fin on both sides of the inverter and into
the bracket (see
Figure 12
). Tighten the screws with a torque of 4.0 N*m / 2.9 lb.*ft.
7. Remove the inverter cover: Open the inverter cover’s six Allen screws and carefully pull the cover
horizontally before lowering it.
Chapter 3: Installing the Inverter
SolarEdge
-
StorEdge Installation Guide MAN-01-00262-1.0
23
