socomec Green Power 2.0 60, Installation And Operating Manual

Page: 6 / 52

6
Green Power 2.0
60-80 kVA - Ref.: IOMMASGPXX06-EN 06
• The packaging guarantees the stability of the UPS during shipping and physical transfer. Carry the packaged unit as close as
possible to the installation site.
2.1. SHIPPING AND HANDLING
• The UPS must remain in a vertical position during all shipping and handling operations.
• Ensure that the floor is strong enough to support the weight of the UPS and battery cabinet, if used.
Avoid pressing the front door when moving the unit
All packaging materials must be recycled in compliance with the laws in force in the country where the system is installed.
2.2. ENVIRONMENTAL REQUIREMENTS
• The recommended operating temperature, humidity and altitude values are listed in the technical specifications table
(see chapter 10). Cooling systems may be required to maintain these values.
• Avoid dusty environments or areas where there is dust from conductive or corrosive materials (e.g. metal dust or chemical solutions).
• The UPS is not designed for outdoor use (see Protection Level on chapter 10).
• Do not expose the UPS to direct sunlight or sources of excessive heat.
• A space of at least 40 cm must be left at the back and 15 cm on both sides for adequate ventilation (see figure 2.2-1 and 2.2-2).
• The UPS switches are accessed from the front; however, a space of at least 1.5 metres should be left at the front of the UPS for
maintenance purposes.
• Do not put any object on top of the UPS.
• A space of at least 80 cm must be left above the UPS (see figure 2.2-3) for maintenance purposes.
2. INSTALLATION OF THE UNIT
2.2-1 2.2-2 2.2-3
≥ 80 cm
15 cm 15 cm 15 cm
15 cm
free area
UPS
or
BATTERY
CABINET
40 cm
UPS
or
BATTERY
CABINET
40 cm
UPS
or
BATTERY
CABINET
40 cm
1,5 m
130°
door
free area
UPS
40 cm
1,5 m
130°
door
15 cm 15 cm