Chapter 3: Setting Up the Monitor
Operation Manual SurgiVet
®
V3404 Plus
3-1
Chapter 3: Setting Up the Monitor
Unpacking the Monitor and Checking the Shipment
Carefully remove the monitor and accessories from the shipping carton. Save the packing materials in case the
monitor or accessories must be shipped or stored. Compare the packing list with the accessories received to
make sure the shipment is complete.
Turning High and Low Priority Alarm Tones On and Off
When the monitor is turned on, the alarm tones are silenced for two minutes. The Alarm Silence indicator
(
)
on the EL display, flashes during the two minute time-out.
To silence the alarm tones indefinitely: Press and hold
B
for about three seconds; the Alarm Silence
indicator lights steady.
NOTE: To comply with government requirements for patient monitoring, the indefinite alarm and alert
tone silence feature may not be available in monitors shipped to your country.
To silence the alarm tones for two minutes: Momentarily press
B
the Alarm Silence indicator flashes. If
tones are already silenced, press
B
twice (the first press cancels alarm silenced; the second press silences
the alarms for two minutes).
To cancel either two minute or indefinite alarm silence and enable alarm and alert tones: Momentarily
press
B
, the Alarm Silence indicator turns off.
Working With Menus
Menu Structure
•
•
•
Alarm
Set SpO2 High and Low Alarms
Set Pulse Rate High and Low Alarms
Set Respiration Rate High and Low Alarms
Setup/Volume
Sweep Speed
Select BPM Source
Adjust Alarm Volume
Adjust Pulse Volume
ECG
Select Lead
Select Size
Enable/Disable Pace Detect
Select Number of Leads
Select the ECG Detection Threshold
Enable/Disable Calibration Monitor Function
Enable/Disable ECG Monitor Function
1mV Calibration Waveform
Oximeter
Select Averaging Parameters
Disable/Enable Oximeter Function
Respiration
Sensitivity Setting
Enable/Disable Respiration Function
Temperature
Units
Enable/Disable Temperature Function
Trends
Select Display Time
Select Trend Display Scales for Each Parameter
Clear Trend Memory
Analog Out
Assign Data/Waveform Output to Each of 2 Channels
Assign Channel 1
Assign Channel 2
Serial Out
Start/Stop Serial Output
Enable/Disable Nurse Call
Select Data Format
Select Printer Type
Select Sweep Speed
