C
OMMAND
L
INE
I
NTERFACE
4-64
Example
The following example shows the event message stored in RAM.
SMTP Alert Commands
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
Table 4-21 SMTP Alert Commands
Command
Function
Mode Page
logging sendmail host Specifies SMTP servers that will be sent
alert messages
GC
4-65
logging sendmail
level
Sets the
severity threshold used to trigger
alert messages
GC
4-66
logging sendmail
source-email
Sets the
email address used for “From”
field of alert messages
GC
4-66
logging sendmail
destination-email
Specifies the email recipients of alert
messages
GC
4-67
logging sendmail
Enables SMTP event handling
GC
4-68
show logging
sendmail
Displays SMTP event handler settings
NE,
PE
4-68
Summary of Contents for 8728L2 - annexe 1
