SMC Networks 8728L2 - annexe 1, Management Manual

Page: 271 / 546

L
INE
C
OMMANDS
4-13
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Table 4-5 Line Command Syntax
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode GC 4-14
login Enables password checking at login LC 4-15
password Specifies a password on a line LC 4-16
timeout login
response Sets the interval that the system waits for a
login attempt LC 4-17
exec-timeout Sets the interval that the command interpreter
waits until user input is detected LC 4-18
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC 4-19
silent-time
*
* These commands only apply to the serial port.
Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the
password-thresh
command
LC 4-20
databits * Sets the number of data bits per character that
are interpreted and generated by hardware LC 4-20
parity * Defines the generation of a parity bit LC 4-21
speed
* Sets the terminal baud rate LC 4-22
stopbits * Sets the number of the stop bits transmitted per
byte LC 4-23
disconnect Terminates a line connection PE 4-23
show line Displays a terminal line's parameters NE,
PE 4-24