M
ULTICAST
F
ILTERING
3-209
CLI
– This example sets a default domain name and a domain list.
However, remember that if a domain list is specified, the default domain
name is not used.
Configuring Static DNS Host to Address Entries
You can manually configure static entries in the DNS table that are used to
map domain names to IP addresses.
Command Usage
•
Static entries may be used for local devices connected directly to the
attached network, or for commonly used resources located elsewhere
on the network.
•
Servers or other network devices may support one or more
connections via multiple IP addresses. If more than one IP address is
associated with a host name in the static table or via information
returned from a name server, a DNS client can try each address in
succession, until it establishes a connection with the target device.
Command Attributes
•
Host Name
– Name of a host device that is mapped to one or more
IP addresses. (Range: 1-64 characters).
Console(config)#ip domain-name sample.com
Console(config)#ip domain-list sample.com.uk
Console(config)#ip domain-list sample.com.jp
Console(config)#ip name-server 192.168.1.55 10.1.0.55
Console(config)#ip domain-lookup
Console#show dns
Domain Lookup Status:
DNS enabled
Default Domain Name:
.sample.com
Domain Name List:
.sample.com.uk
.sample.com.jp
Name Server List:
192.168.1.55
10.1.0.55
Console#
Summary of Contents for 8728L2 - annexe 1
