GVRP
AND
B
RIDGE
E
XTENSION
C
OMMANDS
4-227
Example
show gvrp configuration
This command shows if GVRP is enabled.
Syntax
show gvrp configuration
[
interface
]
interface
•
ethernet
unit
/
port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-30)
•
port-channel
channel-id
(Range: 1-6)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
garp timer
This command sets the values for the join, leave and leaveall timers. Use
the
no
form to restore the timers’ default values.
Syntax
garp timer
{
join
|
leave
|
leaveall
}
timer_value
no garp timer
{
join
|
leave
|
leaveall
}
• {
join
|
leave
|
leaveall
} - Which timer to set.
•
timer_value
- Value of timer.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport gvrp
Console(config-if)#
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
Gvrp configuration: Enabled
Console#
Summary of Contents for 8728L2 - annexe 1
