A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-119
• If a port is already bound to an ACL and you bind it to a different
ACL, the switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to
a port.
Example
Related Commands
show ip access-list (4-117)
show ip access-group
This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ip access-group (4-118)
map access-list ip
This command sets the output queue for packets matching an ACL rule.
The specified CoS value is only used to map the matching packet to an
output queue; it is not written to the packet itself. Use the
no
form to
remove the CoS mapping.
Syntax
[
no
]
map access-list ip
acl_name
cos
cos-value
•
acl_name
– Name of the ACL. (Maximum length: 16 characters)
•
cos-value
– CoS value. (Range: 0-7)
Console(config)#int eth 1/25
Console(config-if)#ip access-group standard david in
Console(config-if)#
Console#show ip access-group
Interface ethernet 1/25
IP standard access-list david
Console#
Summary of Contents for 8728L2 - annexe 1
