S
PANNING
T
REE
C
OMMANDS
4-185
Command Usage
This command sets the maximum time (in seconds) the root device will
wait before changing states (i.e., discarding to learning to forwarding).
This delay is required because every device must receive information
about topology changes before it starts to forward frames. In addition,
each port needs time to listen for conflicting information that would
make it return to the discarding state; otherwise, temporary data loops
might result.
Example
spanning-tree hello-time
This command configures the spanning tree bridge hello time globally for
this switch. Use the
no
form to restore the default.
Syntax
spanning-tree
hello-time
time
no spanning-tree
hello-time
time
- Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root
device transmits a configuration message.
Example
Console(config)#spanning-tree forward-time 20
Console(config)#
Console(config)#spanning-tree hello-time 5
Console(config)#
Summary of Contents for 8728L2 - annexe 1
