B
ASIC
C
ONFIGURATION
3-31
•
Login Timeout
– Sets the interval that the system waits for a user to
log into the CLI. If a login attempt is not detected within the timeout
interval, the connection is terminated for the session. (Range: 0-300
seconds; Default: 300 seconds)
•
Exec Timeout
– Sets the interval that the system waits until user input
is detected. If user input is not detected within the timeout interval, the
current session is terminated. (Range: 0-65535 seconds; Default: 600
seconds)
•
Password Threshold
– Sets the password intrusion threshold, which
limits the number of failed logon attempts. When the logon attempt
threshold is reached, the system interface becomes silent for a specified
amount of time (set by the Silent Time parameter) before allowing the
next logon attempt. (Range: 0-120; Default: 3 attempts)
Available in CLI only:
•
Password
– Specifies a password for the line connection. When a
connection is started on a line with password protection, the system
prompts for the password. If you enter the correct password, the
system shows a prompt. (Default: No password)
•
Login
– Enables password checking at login. You can select
authentication by a single global password as configured for the
Password parameter, or by passwords set up for specific user-name
accounts. (Default: Local)
Web
– Click System, Line, Telnet. Specify the connection parameters for
Telnet access, then click Apply..
Figure 3-15. Enabling Telnet
Summary of Contents for 8728L2 - annexe 1
