SMC Networks 8700S-130, Management Manual

Page: 53 / 592

B
ASIC
C
ONFIGURATION
2-15
MIB-2 tree branch, and then another view that includes the IEEE 802.1D
bridge MIB. It assigns these respective read and read/write views to a
group called “r&d” and specifies group authentication via MD5 or SHA.
In the last step, it assigns a v3 user to this group, indicating that MD5 will
be used for authentication, provides the password “greenpeace” for
authentication, and the password “einstein” for encryption.
For a more detailed explanation on how to configure the switch for access
from SNMP v3 clients, refer to “Simple Network Management Protocol”
on page 3-45, or refer to the specific CLI commands for SNMP starting
on page 4-146.
Saving Configuration Settings
Configuration commands only modify the running configuration file and
are not saved when the switch is rebooted. To save all your configuration
changes in nonvolatile storage, you must copy the running configuration to
the start-up configuration file using the “copy” command.
To save the current configuration settings, enter the following command:
1. From the Privileged Exec level global configuration mode prompt,
type “copy running-config startup-config” and press <Enter>.
2. Enter the name of the start-up file. Press <Enter>.
Console(config)#snmp-server view mib-2 1.3.6.1.2.1 included
Console(config)#snmp-server view 802.1d 1.3.6.2.1.17 included
Console(config)#snmp-server group r&d v3 auth read mib-2
write 802.1d
Console(config)#snmp-server user steve r&d v3 auth md5 greenpeace
priv des56 einstein
Console(config)#
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#