C
OMMAND
L
INE
I
NTERFACE
4-144
match access-list mac
This command changes the IEEE 802.1p priority of a Layer 2 frame
matching the defined ACL rule. (This feature is commonly referred to as
ACL packet marking.) Use the
no
form to remove the ACL marker.
Syntax
match
access-list mac
acl_name
set priority
priority
no
match
access-list mac
acl_name
•
acl_name
– Name of the ACL. (Maximum length: 16 characters)
•
priority
– Class of Service value in the IEEE 802.1p priority tag.
(Range: 0-7; 7 is the highest priority)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
You must configure an ACL mask before you can change frame
priorities based on an ACL rule.
Example
Related Commands
show marking (4-132)
ACL Information
Console(config)#interface ethernet 1/12
Console(config-if)#match access-list mac a set priority 0
Console(config-if)#
Table 4-38 ACL Information
Command
Function
Mode
Page
show access-list
Shows all ACLs and associated rules
PE
4-145
show access-group
Shows the ACLs assigned to each port
PE
4-145
Summary of Contents for 8700S-130
