HGM7110DC Genset Controller
HGM7110DC Genset Controller Version: 1.0 2014-09-27 Page
30
of
68
NO.
Functions
Cable
Size
Remark
39
Aux. Input COM
1.0mm
2
A common terminal of input port, (-Ve) has
already connected internal.
40
CANBUS SCR
0.5mm
2
Impedance-
120Ω
shielding
wire
is
recommended, its single-end earthed. (No
CANBUS, no these terminals)
41
CAN-
0.5mm
2
42
CAN+
0.5mm
2
43
RS485 SCR
0.5mm
2
Impedance-
120Ω
shielding
wire
is
recommended, its single-end earthed. (No
RS485, no these terminals)
44
RS485+
0.5mm
2
45
RS485-
0.5mm
2
46
GND
47
Engine Temp.
Connect to temperature Sensor.
48
Oil Pressure
Connect to oil pressure sensor.
49
Fuel Level
Connect to fuel level sensor.
50
Config. Sensor 1
Connect to temperature sensor,
oil pressure sensor or fuel level
sensor.
Details see form 4
51
Config. Sensor 2
52
Sensor COM
A common terminal of sensor, (-Ve) has
NOT
connected
internal.
53
RS232(GND)
0.5mm
2
Connected to GSM module.
54
RS232 TX
0.5mm
2
55
RS232 RX
0.5mm
2
NOTE: USB ports in controller rear panel are configurable parameter ports, user can
directly program controller via PC.
NOTE: If 1# accumulator/2# accumulator temperatures need to be detected, Configured
sensor 1/ sensor 2 should be set as
“Temperature Sensor”.
