SMART Embedded Computing MC1600, Installation And Use Manual

Page: 91 / 126

MC1600 Extreme Edge Server Installation and Use (6806870A02B) 91
Chapter 4
System Installation
4.1 Introduction
This chapter provides instructions for installing and removing the Extreme Edge Server in
a rack or cabinet. It also provides information and procedures for grounding, powering up
and down, and disconnecting the server from the power feed.
4.2 Before Installation
Refer to Figure 1-1 on page 49 for location of LEDs, connectors and earth ground point.
Before you start the installation, make sure that you have all of the necessary equipment
and tools available.
Provide the following cables:
 Earth grounding cable with an M4 ring lug in case of rack installation

Twisted pair Ethernet cable for connecting the BMC ETH
 Twisted pair Ethernet cable for the front panel ETH1 and ETH2 RJ-45 ports

SFP+ or SFP modules or direct connect copper cables for the five SFP+ ports
The connectivity of the RJ-45 ports to CPU1 and/or CPU2 is covered in Figure 1-1 on page
49 and Section 1.7.2.2, PCIe-Based Gigabit Ethernet on page 57 .
4.3 Install the Extreme Edge Server in the Cabinet
For installation recommendations regarding outside installations, go to Mounting Options
on page 85 .
Usage Equipment and Tools
General
Torque wrench
ESD wrist strap
Server / Rack / Cabinet Four bolts or screws 6mm / 0.24" diameter
Grounding Ground cable 1.25 mm
2
for DC system
Power DC power cable
System Access
USB Type-A to USB Type-A cable
PC or laptop