SMART Embedded Computing MC1600, Installation And Use Manual

Page: 83 / 126

MC1600 Extreme Edge Server Installation and Use (6806870A02B) 83
Chapter 2
Site Preparation
2.1 Introduction
This chapter provides information on unpacking the MC1600 Extreme Edge Server, safety
precautions, and requirements for the product. Included are the environmental and power
requirements, mounting options, cooling considerations, acoustic noise control, and
dimensions and weight of the product.
2.2 Unpacking the Extreme Edge Server
Make sure you receive all items of your shipment:

One MC1600 Extreme Edge Server with PCIe filler plate
 One Extreme Edge Server connector kit: two DC connectors and four crimp
terminals
1. Carefully inspect the server and all shipped components.
2. Request an RMA for product return at https://www.smartembedded.com/ec/support/ if
any damage or discrepancies are observed with the items.
3. Tighten loose screws before proceeding.
4. Remove the desiccant bags delivered together with the system and dispose according
to your country’s legislation.
2.3 Prepare the Installation Site
This section provides the basic site planning and installation requirements.
 440W power should be available for the MC1600 system
 System should be positioned so that a power source is easy to reach
 Sufficient space should be available in racks to install the system
When installing or servicing the system or accessories, strictly observe the safety
precautions noted in this document. Otherwise, personal injury or property damage
may occur. Ignoring these instructions can void the system warranty.
Attach an ESD-preventive wrist strap before operating the product. Both terminals
of the wrist strap must contact well. One terminal touches bare skin and the terminal
with the alligator clip attaches to the grounding lug at I/O panel of the system.