60
ATCA-F140 Series Installation and Use (6806800M67S)
Hardware Preparation and Installation
Hardware Preparation and Installation
2.8
Installing and Removing SFP Modules
This section describes how to install and remove SFP modules.
2.8.1
Installing an SFP Module
Installation Procedure
In order to install an SFP module, proceed as follows:
Eye Damage
Optical SFP modules may emit laser radiation when no cable is connected.
Avoid staring into open apertures to avoid damage to your eyes.
Personal Injury and Damage of the Blade, RTM and SFP Modules
Installing and using SFP modules which are not fully certified and which do not meet
all relevant safety standards may damage the blade, RTM and the SFP modules and
may lead to personal injury.
Only use and install SFP modules which are fully certified and which meet all
relevant safety standards.
Personal Injury
Optical SFP modules may be classified as laser products. When installing and using
any of these SFP modules, the regulations which correspond to the respective laser
class apply to the whole blade and RTM. Non-compliance with these regulations
may lead to personal injury.
When installing and using optical SFP modules which are classified as laser
products, make sure to comply to the respective regulations.
SFP modules can be installed/removed while the blade and RTM is both powered
and or powered off. The presence and also the type of SFP modules is automatically
detected.
The maximum power consumption of each SFP module should be 1W. The
maximum power consumption of each SFP+ module should be 1.5W.
