ATCA-F140 Series Installation and Use (6806800M67S)
19
Safety Notes
This section provides warnings that precede potentially dangerous procedures throughout
this manual. Instructions contained in the warnings must be followed during all phases of
operation, service, and repair of this equipment. You should also employ all other safety
precautions necessary for the operation of the equipment in your operating environment.
Failure to comply with these precautions or with specific warnings elsewhere in this manual
could result in personal injury or damage to the equipment.
SMART Embedded Computing intends to provide all necessary information to install and
handle the product in this manual. Because of the complexity of this product and its various
uses, we do not guarantee that the given information is complete. If you need additional
information, ask your SMART EC representative.
The product has been designed to meet the standard industrial safety requirements. It must
not be used in safety critical components, life supporting devices or on aircraft.
Only personnel trained by SMART EC or persons qualified in electronics or electrical
engineering are authorized to install, remove or maintain the product. The information given
in this manual is meant to complete the knowledge of a specialist and must not be used as
replacement for qualified personnel.
Keep away from live circuits inside the equipment. Operating personnel must not remove
equipment covers. Only factory authorized service personnel or other qualified service
personnel is allowed to remove equipment covers for internal subassembly or component
replacement or any internal adjustment.
Do not install substitute parts or perform any unauthorized modification of the equipment or
the warranty may be voided. Contact your local SMART EC representative for service and
repair to make sure that all safety features are maintained.
EMC
The product has been tested in a standard SMART EC system and found to comply with
the limits for a Class A digital device in this system, pursuant to part 15 of the FCC Rules,
EN 55022 Class A respectively. These limits are designed to provide reasonable protection
against harmful interference when the product is operated in a commercial, business or
industrial environment. The product conducts, radiates and uses radio frequency energy
and, if not installed properly and used in accordance with this user documentation, may
cause harmful interference to radio communications.
Operating the product in a residential area is likely to cause harmful interference. If this
occurs, the user will be required to correct the interference at the user's expense. Changes
or modifications not expressly approved by SMART EC could void the user's authority to
operate the equipment. Board products are tested in a representative system to show
compliance with the above mentioned requirements. A proper installation in a compliant
system will maintain the required performance.
