Simrad SL 30, Manual

Page: 162 / 224

974-25007001/2.0 SL 30/35 Hull Sonar Operators Manual
Page 6.14 Installation, Start-Up and Test
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
6.4.6 Mounting the Transceiver
Mounting pads are incorporated into the tank flange in order to secure the
transceiver unit to the tank flange assembly. Secure the transceiver to the flange
using the supplied hex bolts, flat washers, spring washers and nuts. Apply Loctite
Nickel anti-seize to the threads of the hex bolts before assembling.
See Part 8 “Attachments and Drawings” for detailed assembly information.
6.5 INTERCONNECTION WIRING DIAGRAM
The interconnection wiring diagram for the transceiver unit, hoist unit, hull unit to the
operating panel and interface unit are supplied in Part 8
“Attachments and
Drawings” .
Note: An interconnection drawing is fixed on the inside cover of the transceiver unit.
6.5.1 Motion Sensor Electrical Connection
The interconnection of the transceiver to the motion sensor is supplied with external
pre-wired connectors.
6.6 SL 30 OR SL 35 SYSTEM START-UP AND TEST
Initial power-up, set-up and testing of the system should be made with the vessel
tied to the dock. Ensure there is sufficient water below the keel before you lower the
sonar dome in order not to damage the hull unit.
6.6.1 SL 30/35 Start Up
Check that the system has been properly installed and that all connections have
been made to the operating panel/interface unit, the processing unit and hull unit.
•
Turn ON the power by pressing the power button located on the operating panel
•
Next, turn ON the display monitor, and then turn ON the HP/PC; the system will