Simrad SL 30, Manual

Page: 161 / 224

SL 30/35 Hull Sonar Operators Manual 974-25007001/2.0
Installation, Start-Up and Test Page 6.13
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
tank, taking care not to damage the sonar dome
•
Attach the tank flange assembly to the retraction tank using the supplied hex
bolts, flat washers, spring washers and nuts; do not over tighten the bolts,
otherwise you will damage the flange gasket.
•
Next, position the sonar dome into its final position, by adjusting the V Guide
alignment block. Ensure that the sonar dome is fully retracted into the sonar tank
Note: Apply Loctite, Nickel Anti-Seize to the threads of the hex bolts before
assembling.
•
The main shaft bearing must be greased. Remove the Vent Cap located on the
opposite side of the grease fitting. Using the supplied Shell “SRS 2000” water
resistance grease, fill until the grease comes out from the vent; re-install the
Vent Cap.
See Part 8 “Attachments and Drawings” for detailed assembly information.
6.4.5 Mounting the Hoist Unit
A mounting pad is incorporated into the tank flange in order to secure the
lower/raising ram assembly.
To secure the lower/raising assembly:
•
Insert the clevis pin into position and secure in place by installing the hair-pin clip
supplied with the system
•
Install the Vent Cap on the oil reservoir, then manually raise the RAM unit by
using the manual hand pump located on the hoist unit to its full “UP” position
•
Slide the upper hoist retainer clamp from the top of the shaft into position
•
Secure the upper part of the hoist unit in place using the clevis pin and hair-pin
clip. Fix the upper shaft and hoist retainer clamp using the supplied hex bolts, flat
washers and lock nuts; apply Loctite Nickel Anti-Seize to the threads of the hex
bolts and the shaft before assembling
•
Next, mount the Ram Alignment Guide on the Ram hoist unit; additional care
must be taken to properly align the hoist unit
•
Install the cable gland on the top of the shaft
See Part 8 “Attachments and Drawings” for detailed assembly information.