Simrad SL 30, Manual

Page: 151 / 224

SL 30/35 Hull Sonar Operators Manual 974-25007001/2.0
Installation, Start-Up and Test Page 6.3
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
6. INSTALLATION, START-UP AND TEST
6.1 INSTALLATION PROCEDURE
The installation of the SL 30/35 Hull Sonar involves the following steps:
• Deciding on the locations in the wheelhouse for the surface units.
• Mounting the surface units and making the connections between the SL 30/35
Processing Unit, Keyboard/Interface Unit, the Display Unit and other optional
equipment being installed.
• Assembling the Hull Unit in the sonar room.
• Mounting the Hull Unit and completing all aspects of the installation.
• Running up the system to verify proper operation, system configuration and
perform initial system tests.
6.2 SURFACE UNIT ELECTRONICS INSTALLATION
The following section will describe the installation procedure for the bridge unit
requirements.
6.2.1 Mounting of Units
The display unit should be located in the wheelhouse in a place that provides a good
view of the screen and avoids direct sunlight, if possible. Depending on the monitor
that was selected, the unit may be mounted on top or recessed into the bridge
console. Simrad supplied display units include the necessary mounting brackets.
The SL 30/35 Operating Panel unit should be mounted in close vicinity to the
operator's position in the wheelhouse and near the display unit. The unit may be flush
mounted into the bridge console.
The Processing Unit may be mounted inside the bridge console. Sufficient space
should be left around the processing unit for proper ventilation.
Optional equipment for interface to the processing unit may be mounted in any
convenient location, provided the user supplied interconnect cables are of sufficient
length and the required power is available.