Siemens SINAMICS V20 Inverter, Operating Instructions Manual

Page: 291 / 426

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
289
Parameter Function Range Factory
default
Can be
changed
Scaling Data
set
Data
type
Acc.
Level
r2053[0...7] I/O Extension Module
identification
- 0 - - - U16 3
Displays identification data of the I/O Extension Module.
Index: [0] I/O Extension Module ID number
[1] I/O Extension Module firmware version number (major)
[2] I/O Extension Module firmware version number (minor)
[3] I/O Extension Module firmware version number (hot fix)
[4] I/O Extension Module firmware version number (internal)
[5] Not used
[6] Not used
[7] Company ID (Siemens = 42)
r2067.0...12 CO/BO: Digital input
values status
- - - - - U16 3
Displays status of digital inputs.
Bit Signal name 1 signal 0 signal
00 Digital input 1 Yes No
01 Digital input 2 Yes No
02 Digital input 3 Yes No
03 Digital input 4 Yes No
04 Digital input 5 Yes No
05 Digital input 6 Yes No
11 Digital input AI1 Yes No
12 Digital input AI2 Yes No
Note: This is used for BICO connection without software intervention.
The digital input 5 and 6 are provided by the optional I/O Extension Module.
P2100[0...2] Alarm number selection 0 - 65535 0 T - - U16 3
Selects up to 3 faults or alarms for non-default reactions.
Example: If, for example, an OFF3 is to be carried out instead of an OFF2 for a fault, the fault number has to be
entered in P2100 and the desired reaction selected in P2101 (in this case (OFF3) P2101 = 3).
Index: [0] Fault Number 1
[1] Fault Number 2
[2] Fault Number 3
Note: All fault codes have a default reaction to OFF2.
Only the following faults (F11,F12,F20,F35,F71,F72,F85,F200,F221,F222, and F452) can be changed
from the default reactions.