Siemens SINAMICS V20 Inverter, Operating Instructions Manual

Page: 227 / 426

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
225
Parameter Function Range Factory
default
Can be
changed
Scaling Data
set
Data
type
Acc.
Level
P0704[0...2] Function of digital input 4 0 - 99 15 T - CDS U16 2
Selects function of digital input 4.
See P0701.
P0705[0...2] Function of digital input 5 0 - 99 16 T - CDS U16 2
Selects function of digital input 5.
See P0701.
Note: This digital input is provided by the optional I/O Extension Module.
P0706[0...2] Function of digital input 6 0 - 99 17 T - CDS U16 2
Selects function of digital input 6.
See P0701.
Note: This digital input is provided by the optional I/O Extension Module.
P0712[0...2] Analog/digital input 1 0 - 99 0 T - CDS U16 2
Selects function of digital input AI1 (via analog input).
See P0701.
Note: See P0701. Signals above 4 V are active; signals below 1.6 V are inactive.
P0713[0...2] Analog/digital input 2 0 - 99 0 T - CDS U16 2
Selects function of digital input AI2 (via analog input).
See P0701.
Note: See P0701. Signals above 4 V are active; signals below 1.6 V are inactive.
P0717 Connection macro 0 - 255 0 C(1) - - U16 1
Selects a given connection macro, which is a set of parameter values for a given set of control connec-
tions. There are a number of connection macros which define basic control connection settings such as
Terminals, BOP, PID with analog setpoint etc.
Note: Please note that to guarantee correct setting of the Connection macro, the Connection macro number
should only be changed during Setup directly after a parameter reset.
P0719[0...2] Selection of command &
frequency setpoint
0 - 57 0 T - CDS U16 4
Central switch to select control command source for converter. Switches command and setpoint source
between freely programmable BICO parameters and fixed command/setpoint profiles. Command and
setpoint sources can be changed independently. The tens digit chooses the command source and the
units digit chooses the setpoint source.
0 Cmd = BICO parameter, Setpoint = BICO parameter
1 Cmd = BICO parameter, Setpoint = MOP setpoint
2 Cmd = BICO parameter, Setpoint = Analog setpoint
3 Cmd = BICO parameter, Setpoint = Fixed frequency
4 Cmd = BICO parameter, Setpoint = USS on RS232 (reserved)
5 Cmd = BICO parameter, Setpoint = USS/MODBUS on RS485
7 Cmd = BICO parameter, Setpoint = Analog setpoint 2
40 Cmd = USS on RS232 (reserved), Setpoint = BICO parameter
41 Cmd = USS on RS232 (reserved), Setpoint = MOP setpoint
42 Cmd = USS on RS232 (reserved), Setpoint = Analog setpoint
43 Cmd = USS on RS232 (reserved), Setpoint = Fixed frequency
44 Cmd = USS on RS232 (reserved), Setpoint = USS on RS232 (reserved)