UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
312 A50010-Y3-C150-2-7619
sage in response. It is normally the loopback interface address, but can also be other
physical addresses. This address must be advertised by unicast routing protocols on the
DR.
Command Mode
Description
ip pim register-source
{
A.B.C.D
|
INTERFACE
}
Configures the source address of register message.
A.B.C.D: IP address to be used as source
INTERFACE: interface address to be used as source
no ip pim register-source
Global
Disables the registration suppression time.
By default, the IP address of the outgoing interface of the DR leading to the RP is used as
the IP source address of a register message.
9.3.5.5
Reachability for PIM Register Process
To enable the RP reachability verification for PIM Register processing at the DR, use the
following command.
Command Mode
Description
ip pim register-rp-reachability
Enables the RP reachability verification function.
no ip pim register-rp-reach-
ability
Global
Disables the RP reachability verification function.
(default)
This command is disabled by default.
9.3.6 SPT
Switchover
This command is used to enable and configure the bandwidth of the switchover from RPT
to SPT for the certain group. If a source sends at a rate greater than or equal to traffic
rate (the kbps value), a PIM join message is triggered toward the source to construct a
source tree. Specifying a group list access list indicates the groups to which the threshold
applies. If the traffic rate from the source drops below the threshold traffic rate, the leaf
router will switch back to the shared tree and send a prune message toward the source.
Command Mode
Description
ip pim spt-threshold
Enables the ability for the last-hop PIM router to switch
to SPT.
ip pim spt-threshold group-list
{<1-99> | <1300-1999> |
AC-
CESS-LIST
}
Enables the ability for the last-hop PIM router to switch
to SPT for multicast group addresses specified by the
given access list.
no ip pim spt-threshold
no ip pim spt-threshold group-
list
{<1-99> | <1300-1999> |
AC-
CESS-LIST
}
Global
Disables switching to SPT option.
i
