UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
112 A50010-Y3-C150-2-7619
7.1.8.5 Displaying
SNMP
Trap
To display a configuration of SNMP trap, use the following command.
Command Mode
Description
show snmp trap
Enable
Global
Shows a configuration of SNMP trap.
The following is an example of configuring IP address 10.1.1.1 as trap-host, 20.1.1.1 as
trap2-host and 30.1.1.1 as inform-trap-host.
SWITCH(config)#
snmp trap-host
10.1.1.1
SWITCH(config)#
snmp trap2-host
20.1.1.1
SWITCH(config)#
snmp inform-trap-host
30.1.1.1
SWITCH(config)#
show snmp trap
Trap-Host List
Host Community
------------------------------------------
inform-trap-host 30.1.1.1
trap2-host 20.1.1.1
trap-host 10.1.1.1
Trap List
Trap-type Status
--------------------------
auth-fail enable
cold-start enable
cpu-threshold enable
port-threshold enable
dhcp-lease enable
power enable
module enable
fan enable|
temp-threshold enable
SWITCH(config)#
7.1.9 SNMP
Alarm
The hiD 6615 S223/S323 provides an alarm notification function. The alarm will be sent to
a SNMP trap host whenever a specific event in the system occurs through CLI and ACI-E.
You can also set the alarm severity on each alarm and make the alarm be shown only in
case of selected severity or higher. This enhanced alarm notification allows system ad-
ministrators to manage the system efficiently.
7.1.9.1 Enabling
Alarm
Notification
To configure whether the switch enable transmitting SNMP alarm or not, use the following
command.
Command Mode
Description
snmp notify-activity
{
enable
|
disable
}
Global
Enables/disables an alarm notification on CLI or ACI-E.
(default: disable)
