Siemens MXL-IQ, Operation, Installation, And Maintenance Manual

Page: 170 / 180

O-2
Appendix O
the timer if the delay time is other than zero.
No AC failure trouble is reported at this time.
At the end of this delay time, if the AC still
fails, the MXL-IQ posts the AC Failure
trouble; otherwise, it goes back to the
original state.
CCU Pager Interface
A new selection is added to the list of
printer selections under the Global MKB in
the Network map of the CSG-M: CCU/M
Pager Interface. The new selection
provides a remote interface between the
MXL-IQ panel and the operator.
This selection is available in all situations
where a printer was previously available.
For a 72 Proprietary networked system
(72D system), this selection is available
under a Display Only Global MKB. There
are only two selections in this configuration:
NONE and CCU/M.
When programmed into the CSG-M, this
pager interface can be either supervised or
unsupervised. The CCU/M interface is an
application specific output device, and not a
global MKB printer for a 72D system. There-
fore, if it is installed on a 72D networked
system, it does not satisfy the compile
check for a supervised printer. To pass this
compile error, add a supervised printer to a
local MKB in every node in a 72D system.
Despite the above limitation, in both 72A
and 72D systems the CCU/M interface
counts as one GMKB printer available in a
networked system.
Only the normal print messages for events
are sent to the CCU/M interface. Informa-
tion such as acknowledge, reset, time
changes, etc., do not output. The output
formatting is considered as a generic ASCII
printer.