Virtual Network configuration
A31003-W1040-U101-1-7619, July 2006 DRAFT
178
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Defining priority level for VNS traffic
11. Define rules that allow access to the DNS server, to the Telephony Gateway, and then deny
all other traffic. For more information, see Section 7.6, “Configuring filtering rules for a
VNS”, on page 153.
12. Click the
Privacy
tab.
13. Configure privacy to use 104-bit WEP key. This is recommended for greater security. For
more information, see Section 7.8, “Configuring privacy for a VNS”, on page 167.
14. Click the
QoS Policy
tab.
15. Configure the priority levels. For more information, see Section 7.11, “Configuring Quality
of Service (QoS)”, on page 180.
For a VoIP VNS, you should select the voice priority level that is the highest priority value
allowed by the system.
16. To save your changes, click
Save
.
To configure a Wireless AP radio for a voice traffic VNS
1.
From the main menu, click
Wireless AP Configuration
. The Wireless AP screen appears.
2.
In the left pane, click the Wireless AP you want to configure for voice-over-IP traffic. The
AP Properties tab is displayed.
3.
Select one of the following tabs:
●
802.11b/g
●
802.11a
4.
In the
Enable Radios
section, select the appropriate radio checkboxes.
5.
In the
Radio Settings
section, modify the following values:
●
Min Basic Rate
●
Max Basic Rate
●
Max Operational Rate
>
The most popular level of security support is 104-bit WEP key. (Although, newer
phones support WPA-PSK, which is considered a better method). Select the
method that is better suited for your deployment and for the type of devices that
are deployed on your network.
>
Voice priority is required for use with SpectraLink phones.
Summary of Contents for HiPath C10
Page 299: ......
