Virtual Network configuration
A31003-W1040-U101-1-7619, July 2006 DRAFT
158
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Configuring filtering rules for a VNS
●
Select
IP/Port.
●
Type the default gateway IP address that you defined in the Topology tab for this VNS.
7.
Click
Add
. The information appears in the
Filter Rules area of the tab.
8.
Select the new filter, then do the following:
●
If applicable, select
In
to refer to traffic from the wireless device that is trying to get on
the network.
●
If applicable, select
Out
to refer to traffic from the network host that is trying to get to
a wireless device.
●
Select the
Allow
checkbox applicable to the rule you defined.
9.
Edit the order of a filter by selecting the filter and clicking the
Up
and
Down
buttons. The
filtering rules are executed in the order you define here.
10. To save your changes, click
Save
.
7.6.2.1
Non-authenticated filter examples
A basic non-authenticated filter for internal Captive Portal should have three rules, in the
following order:
>
Administrators must ensure that the non-authenticated filter allows access to the
corresponding authentication server:
●
Internal captive portal – IP address of the VNS interface
●
External captive portal P – IP address of external captive portal server
In
Out
Allow IP / Port
Description
x
x
x
IP address of default
gateway (VNS Interface
IP)
Allow all incoming wireless devices access
to the default gateway of the VNS.
x
x
x
IP address of the DNS
Server
Allow all incoming wireless devices access
to the DNS server of the VNS.
x
x
*.*.*.*
Deny everything else.
Table 7
Non-authenticated filter example A
>
For external Captive Portal, an additional rule to Allow (in/out) access to the external
Captive Portal authentication/Web server is required.
Summary of Contents for HiPath C10
Page 299: ......
